MR2 Owners Club Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,413 Posts
Discussion Starter #1
trying to troubleshoot my heating problem, the blower isn't working, I found that the relay wasn't working correctly and replaced that, but the fan still doesn't work. the BGB says to check the resistor, however it doesn't show where it's located.

anyone know the location?

thanks
 
Y

·
Guest
Joined
·
0 Posts
Looking at the parts diagram...it looks like it installs from the front of the fan blower case under the dash towards to top.

I bet if you remove the glove box you could see it through the dash.
 

·
Premium Member
Joined
·
10,360 Posts
It is under the glovebox like yotaman said. Pull the GB out and you will see it screwed into the air plenum
 

·
Registered
Joined
·
1,413 Posts
Discussion Starter #5
removed the glovebox couldn't see anything that looked like the resistor. however I fixed the problem, the blower fan wire was loose.

but if anyone knows the actual location, please post it for future reference.
 

·
Registered
Joined
·
1,413 Posts
Discussion Starter #6
86AW11 said:
It is under the glovebox like yotaman said. Pull the GB out and you will see it screwed into the air plenum
if you were looking at the blower where is the physical location of the resistor from that point?
 

·
Premium Member
Joined
·
10,360 Posts
Its closer to the center console. On the top of the plenum. It is square with a three or four wire plug connected to it.
 
1 - 7 of 7 Posts
Top