MR2 Owners Club Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,286 Posts
Discussion Starter #1
Well I did post this in "general" already but since nobody's responded (to either question I asked mind you... :rolleyes: ) I'm posting this here since I think its sort of urgent...

http://home.comcast.net/~filewhore3/CIMG0401.AVI

Basically while i was doing my cap/rotor I tried to wiggle the ssqv to see if it was coming loose. The whole bov wasn't coming loose, just the body/shell thing that fits over the bov is. I don't want it to get any worse as I'm driving along, have the thing fall apart! What fasteners are loose and how can I tighten them? Am I probably missing the hex bolts that fit in the little holes all around the front? Because of where the bov is I can't really get my eyes at the right angle to tell.
 

·
Registered
Joined
·
195 Posts
look at the part of the bov that says hks ssqv... there are hex bolts in there.. just tighten them up .. ive done this to mines a couple times
.. i think there are like 10 or 12 bolts
 
1 - 3 of 3 Posts
Top