MR2 Owners Club Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,006 Posts
Discussion Starter · #1 ·
if my piston rings are fried like i suspect, im going to have to remove the head. I am planning a ct-27 and about 250whp. i would like to follow the 60-70% rule so what head gasket should i use? will oem be alright?
 

·
Finally running!!
Joined
·
1,125 Posts
from what I understand metal headgaskets are only necessary when you deck blocks and need to make up for the metal you shaved off but if there is a thin metal headgasket it wouldn't hurt to upgrade a bit. I myself have the TTE headgasket ATS sells but I did get my block decked.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top