MR2 Owners Club Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
just got shifter cable bushing kit.
I went out to car, and try to find the those 2 cables.
Where is it?
i didn't jack up yet, b/c i got test tonight-_-.
anyways, i will jack it up tomorrow, and try to find it.
It has to be install from bottom of the car, isn't it?
 

·
Registered
Joined
·
6,985 Posts
They go through the firewall and connect directly to the transmission.
You will need to get the car up in the air...but it should be fairly obvious once you get under there.
 

·
They call me LUCKY!
Joined
·
4,923 Posts
ive dont it from the top ive done it from the bottom... easier from down below, when you slide under the drivers side of the car they will be in plain view
 

·
Registered
Joined
·
413 Posts
I also have the kit, I am debating on installing it. Can any of you tell a difference with them installed? What does it feel like?

Jeb
 

·
They call me LUCKY!
Joined
·
4,923 Posts
the twos r us bushings are straight brass inserts right?

i have something a bit different, i used barrings so the shaft would spin freely. it was over a year since the last time i drove the car before i installed them so i would not be a good source to tell you a diff
 

·
Registered
Joined
·
2,225 Posts
Your talking about the brass inserts right. You can pull off the intake and they're right there on top. I installed mine on top, but either way, top or bottom they're not to hard to install. Just make sure you pay attention to which cable is which, it says in the instructions, the bushings matter which cable they go in. They are slightly different from each other.
 
1 - 9 of 9 Posts
Top