MR2 Owners Club Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
322 Posts
Discussion Starter #1
Shooting for approx. 260whp and am planning on buying a clutch. Sounds like the SPEC Stage 2 is the mayor of clutch land, do you guys recommend this?

Hell, while I have the car apart I'm going to put in a L/W flywheel, any suggestions for this?

As always, can someone refer me to somewhere with competative prices for these?

Thx.
 

·
Registered
Joined
·
4,023 Posts
yes i'm pretty sure everyone can recommend that clutch....i have a RPS clutch silimar to the spec sg3 but better (IMO). you don't need a L/W flywheel, however, i would highly recommend resurfacing the old one......
 

·
Registered
Joined
·
694 Posts
I was choosing between the spec stage 2 and the cm stage 3 and chose the latter only because I read a few posts that some had problems with chatter with the spec. I have heard no problems with the cm3's that have been produced in the last few years. I love mine. You will hear lots of good stories about the spec stage 2 also.
 

·
Registered
Joined
·
1,342 Posts
try to overshoot by some margin, in how much you are looking to put down wiht the clutch your about to order. if your looking for 280-300rwhp, get one that suits 350rwhp just fine, not some 450rwhp+ clutch you know.

word to the wise.

james
 
1 - 4 of 4 Posts
Top