MR2 Owners Club Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter #1
Does anyone know what size flat wrench is needed for unscrewing the oil pressure sender? also does anyone know the thread pitch so i dont have to waste time finding a oil pressure tester that fits.

thanks in advance
 

·
Registered
Joined
·
136 Posts
Discussion Starter #3
I have done so. Only information I can get is people being PRETTY SURE its so and so, because people meticulously word everything.

From what i understand the mk2 has 1/8 in bspt which MIGHT be the same size as the 16v.

also can't find anything on the size of the tool needed to unscrew the thing.
 

·
Registered
Joined
·
2,114 Posts
I have done so. Only information I can get is people being PRETTY SURE its so and so, because people meticulously word everything.

From what i understand the mk2 has 1/8 in bspt which MIGHT be the same size as the 16v.

also can't find anything on the size of the tool needed to unscrew the thing.

Dude,


Yup, they use the same oil pressure sender. Same sender that Toyota used on a lot of different vehicles from the mid 1980s to the mid 1990s.



- Chester
 

·
Registered
Joined
·
136 Posts
Discussion Starter #5
thanks Chester.

Also for the size of the tool used to remove it, from what i vaguely remember from last time it was a 14 mm is that correct?
 
1 - 7 of 7 Posts
Top