MR2 Owners Club Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
508 Posts
Discussion Starter · #1 ·
I think I need to replace the o rings and seals on the oil cooler. I had replaced the HFH last year but I don't think it took. So it might be the hose again or the oil cooler. Is there such a thing an oil cooler rebuild kit or do I have to get the parts seperately? If seperate, does anyone have the part numbers for these parts? :smile:
 

·
Registered
Joined
·
175 Posts
Don't know if there is a 'kit'.
I've got part #'s for the seals I used when I did the HFH, if you want them.
Didn't you replace all those when you did your HFH?
 

·
Registered
Joined
·
508 Posts
Discussion Starter · #3 ·
No I didn't. I thought that I would of been ok with just replacing the hose. It would be great if you post the part numbers or email them to me at [email protected]. Thanks.
 

·
Registered
Joined
·
1,084 Posts
Two for pewter base to block
15517-88380 O ring, oil cooler bracket #1
96732-19019

Between oil cooler and pewter base
15785-35010
90301-52002

These are for a 1990 alltrac with 3sgte, should be the same
 

·
Registered
Joined
·
175 Posts
Those #'s look a lot like mine <g> with these exceptions:

Mine says 90301--52006. It's hand written on the package, so could be wrong.

I also used a 'rectangular' gasket, 16258-88383. Not exactly sure where, though.

HTH
Thon
 
1 - 6 of 6 Posts
Top