MR2 Owners Club Forum banner

21 - 30 of 30 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #21
I have finally started building the firewall. This is a complex ten piece structure which will have to access ports to work on the engine. I made a sheet metal bending break as shown and used a bead roller from harbor freight for design/structure.
 

Attachments

·
Registered
Joined
·
17 Posts
Discussion Starter #22
Here is the first firewall fitment (rough fitment). I still need to make the upper section with access panel as well as two lower sections. You can see where i cut out the center and made the center panel overlay. This took a ton of time.
 

Attachments

·
Registered
Joined
·
5 Posts
I have been working on this one piece engine lid for the last four months. It's not done yet. Now I'm working on the center louvre's. They will be carbon fiber



Sent from my iPhone using Tapatalk
 
21 - 30 of 30 Posts
Top