MR2 Owners Club Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
195 Posts
Discussion Starter #1 (Edited)
Upper L&R Lip Spoiler Retainers and Lower L&R Lip Spoiler Retainers.
  • Upper Retainers:
  • 3D Scanned Profile from OEM Part
  • Water Jet Cut from .1875in Thk 6061-T6 Aluminum
  • Direct Replacement for OEM Spoiler Retainer
  • Uppers are 390% Stiffer than OEM (ran simulation)
  • Works for both Left or Right Side
  • Replaces OEM p/n's: (76857-17020) & (76858-17020)
  • Lower Retainers:
  • 3D Scanned Profile from OEM Part
  • Water Jet Cut from .1875in Thk 6061-T6 Aluminum
  • Direct Replacement for OEM Spoiler Retainer
  • Uppers are 50% Stiffer than OEM (ran simulation)
  • Works for both Left or Right Side
  • Replaces OEM p/n's: (76864-17020) & (76863-17040)
  • Comes with Stainless Steel Hardware
These are the 2nd configuration from the "76864-17020 & 76863-17040 Spoiler Retainer, FR & FL (make it cause you cant get it anymore series)" Thread.

They attach in a different method (I am personally using this configuration) Carriage bolts as semi-permanent studs, much like OEM.

They work together as a set, so you'd need both.

$70 per set + $10 for anywhere in the US

* as of 9/16/2020 there are 4 sets available
** also, you are going to need a real hammer... not a rubber mallet ;-)
 

Attachments

·
Moderator
Joined
·
4,021 Posts
This is awesome. Now if only someone could come up with an accurate reproduction of the 93+ front lip. The typical ebay ones lack the necessary extension underneath to allow you to secure the two underbody panels to the lip.
 

·
Registered
Joined
·
195 Posts
Discussion Starter #3
Thanks!

So you wanna take two sets off my hands so I can use the money to prototype the Upper and Lower Center Retainers ;) I'll cut you a deal of $140 shipped
 
1 - 7 of 7 Posts
Top