MR2 Owners Club Forum banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,348 Posts
Discussion Starter · #1 ·
so long story short here i had removed the drivers side seat belt assembly from the bottom of my car. it was dangling there because i had not done anything with the top part yet. well it was still in the way dangling so i removed the top part as well. well in the process it managed to retract itself further into the lower portion where the belt retracts into. well it will not pull out/extend the belt length for me to be able to get it to reach so i can reinstall it again. it's only got like two feet of belt out total. anyone have any ideas? we tried just about everything we could think of to no avail. surely someone else has done this... with as many dingos having installed aeroware sidevents... anyone?

many thanks in advance!
 

·
Registered
Joined
·
2,225 Posts
You have to bolt one end down and then pull on it. It should release, I had the same problem before. I forget which end I bolted down though.
 
1 - 2 of 2 Posts
Top