HOSE SUB-ASSEMBLY, WATER - Part Number: 8720917010 - Supersession(s): 87209-17010

ALEXSOL · 2023-04-02T17:59:49-0400

if it's no longer available at toyota dealer, possible to make one with copper, aluminum or plastic?

Online · 2023-04-02T20:14:52-0400

Thanks for the post. I have absolutely no idea how to go about that, will have to do some research. Or, might you know places that can?

ALEXSOL · 2023-04-02T20:35:07-0400

if you need the part, then I assume you have it out and it has failed? Are you doing this fix on your own, have the tools or some tools and some mechanical skill? It looks like a T fitting for coolant hose though I'm just guessing from the picture of the part number. Suggest to measure the diameter of the part and find replacement. Can you take a picture?

Online · 2023-04-06T00:22:28-0400

I am not fixing it on my own. Yes, I am looking for only the t-pipe. Could it possibly have been used in a different vehicle by Toyota, just the actual t-pipe? It's still installed my car.

Online · 2023-04-06T00:22:47-0400

I do have a picture of it from another person. I will look for it.

Online · 2023-04-06T00:47:13-0400

Font Gas Auto part Automotive tire Metal

1950884 · 2023-04-06T08:33:02-0400

That seems like a generic part. Have you checked McMaster Carr?

ALEXSOL · 2023-04-06T08:36:58-0400

EDGE INDUSTRIAL 3/4" X 3/4" X 1/2" Hose ID Brass Hose Barb TEE SPLICER Fitting Fuel/AIR/Water/Oil/Gas/WOG (Qty 1): Amazon.com: Industrial & Scientific

www.amazon.com

looks kinda like this...

Cylinder Automotive exhaust Metal Plumbing fitting Fashion accessory

rande · 2023-04-06T11:28:18-0400

When I was building my brake pressure bleeder I found that Menards carries many of these brass fittings in store. If you have a Menards local they could be a good place to look.

ALEXSOL · 2023-04-06T11:33:50-0400

Rande, i counted 30 mr2s!! were they scrap or decent to nice running ones... and so you might know a thing about the mr2... i've gotten in the mr2 game two years ago and have since bought 2 x 4age (long blocks) and one c52 trans.. was staring at the k24 in my garage (at home) and wondering how to mate them... k24 came out of crv so has 160/160 hp/tq... which would be amazing and a k24 from the mid 2000s civic would be even better...

so to stay on topic... OP aka mr. online (pretty sure that's not his real name - though pretty sure it's a dude... who else buys these cars! haha! ) listen to Rande - check out Menards!!

Online · 2023-04-07T08:43:25-0400

Great! Thanks for pointing me in the right direction. I just need to figure out how to measure the t-pipe as it is still installed. Unless either of you know for certain the measurements? Is the 3/4, 3/4, 1/2 an example or the actual t-pipe size I need?

ALEXSOL · 2023-04-07T10:42:03-0400

I've actually never seen this pipe on my aw11 or maybe i did and did not notice the T-fitting. i have purchased new rad/coolant hoses and recall they are about 1" inside diameter give or take... but they don't actually spec it out...