MR2 Owners Club Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hey guys I just got my gen 2 3sge swap running and went to go drive it and won’t go into gear. So I pull the engine back out and split the tranny from the engine and saw no obvious issues. I think I’m using the wrong flywheel or possibly clutch kit. What’s on the engine now is a 3sge flywheel and a 5sfe disc, pressure plate and throw out bearing. Can anyone tell me what work for you on the swap. The trans is a s54. Thanks everybody.
 

·
Registered
Joined
·
5,951 Posts
Can you spin the input shaft of the transmission by hand and get the cv axles to spin? Does the clutch disk have the same splines as the input shaft of the transmission? Does the pressure plate clamp down on the clutch disk?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
Hey got the car shifting it ended up being the wrong clutch disc and pressure plate. I got the “stage 2” clutch kit on eBay for 79 dollars so I guess my mistake... Anyways what I’m using is a Luk clutch kit for s54 and a 3sge flywheel.
 
1 - 5 of 5 Posts
Top