MR2 Owners Club Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,446 Posts
Discussion Starter · #1 ·
Short block was cleaned and painted after removing from car. Vin on block from 1991 model. Already bored .040 over. It will need to be honed to get bore true. Due to this I’d recommend for builds less than 400hp. A heli-coil has been installed on one of the engine to trans bolt holes. I can include crank, stock pistons or rods, mains, etc for extra.
Bare block $400.

Cylinder head should be ready to install. I had new supertech intake valves installed and milled flat around 5,000 miles ago. I can include buckets, shims, valve cover, or factory cams for extra. A heli-coil has been installed in one of the exhaust studs and t-belt tensioner holes.
Bare cylinder head $600.

Located in south bend Indiana.
 

Attachments

1 - 2 of 2 Posts
Top