MR2 Owners Club Forum banner

1 - 3 of 3 Posts

·
Registered
1991 2GR SW20
Joined
·
48 Posts
Discussion Starter #1
I had my non-lsd passenger side (right) axle stub machined by KO RACING to work with the E153 lsd. HOWEVER IT WILL NOT FULLY SEAT INTO THE TRANS!

It appears to have been machined at the spline but perhaps the second lip wasn't machined and that's where it's binding?

Does anyone have machined axle measurements or any insight why it's not working? I'm stuck and don't know what to do
IMG_20200801_103441.jpg
IMG_20200801_103436.jpg
 

·
Registered
Joined
·
1,252 Posts
Customer contacted me - I offered to machine these back further if he needed but I did the same amount I normally do and test fit into the trans before shipping them out. Turns out he's installing on a 2GR and the carrier bracket doesn't sit in the same spot on those.
 
1 - 3 of 3 Posts
Top