MR2 Owners Club Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4,023 Posts
Discussion Starter #1
this is the intake manifold i'll be using for my setup. stocker just hacked up and customized. its made out of T6 aluminum all tig welded. retains the cold start injector and it has the stock TB flange, on the passenger side (most people have theirs on the drivers side). the piping should be shorter for the TMIC that is in the works, just one u-bend vs. one u-bend and a 90 degree bend. anyways, here are the pics:

http://pg.photos.yahoo.com/ph/flynhighaf23/detail?.dir=c494&.dnm=c201.jpg&.src=ph

http://pg.photos.yahoo.com/ph/flynhighaf23/detail?.dir=c494&.dnm=f51d.jpg&.src=ph

i'm looking for some comments and/or opinions on what everyone thinks....post freely!! :thumbup or :thumbdown
 

·
Registered
Joined
·
1,170 Posts
looks nice and good luck with the setup
 

·
Registered
Joined
·
4,023 Posts
Discussion Starter #5
93smgturbo said:
Good job Casey. It looks good. What throttle body will you use with it?
i'll use the stocker for now with the ATS inlet. i had the manifold made so i can always weld on a different flange for a larger TB in the future...
 

·
Registered
Joined
·
4,023 Posts
Discussion Starter #7
not sure who made it, i bought it from a group buy off honda-tech.com. the dimensions are 31X12X3 or something like that...i'll try to take some pics later.
 
1 - 7 of 7 Posts
Top