MR2 Owners Club Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
2,553 Posts
Discussion Starter #1
I'm trying to figure out how wide and tall of a wing to get.

Can someone measure the width of the flat part of trunk, as well as the overall width of the rear. Also need the height from the engine cover to the top of the roof.

Thanks

-Scott
 

·
The System Is Startup!
Joined
·
1,942 Posts
I'll go over and get it for you today
 

·
The System Is Startup!
Joined
·
1,942 Posts
The flat part of the trunk is 49in wide and 16.5 inches long.

However, I'm a retard and didn't read your entire post. so I'll get the remaining mesurnments to you tomorrow. Because like you my car is not at my house, however mine is closer.

But which part of the over all length of the car do you want? From the end of the fenders? or where?
 

·
The System Is Startup!
Joined
·
1,942 Posts
OK at last!

Height From engine lid to roof top 12.5in

Trunk dementions Flat Part: Length 16.5in Width 46in out to 49in at the top (at engine lid)

From the Middle of the trunks Flat part: The Quarter Pannels stick out an additional 8in per side.

Does that help?

Adam
 

·
Registered
Joined
·
2,553 Posts
Discussion Starter #7
Thanks Adam. That does help.

The wing I am looking at is 16" tall, and 56" wide. That seems way too big for my tastes. I think I'll have to make a cardboard one and see how it looks. I should be able to do it this weekend.

I've seen other wings with a 12" height and spans of 52", 54" and 56". Hopefully I can find one with the right combination that looks right.

-Scott
 

·
Registered
Joined
·
27,751 Posts
I think the 16" tall by 56" wide seems reasonable.

Do you know the width of said wing?
 
1 - 9 of 9 Posts
Top