MR2 Owners Club Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
hey guys

i have a AP engineering powerfc

my car is a 1992 JDM, basically i wired in the MAT sensor as says so into the black and brown wire on the AFM wiring. and got that to work but the one problem i have is that on the commandor i am getting 0v on the O2 sensor and have a sensor called THE which is highlighted. The engine runs well at idle but if i apply any throttle the car overfuels big time and throws black smoke out of exhaust.

also after a while the car idles goes up and down automatically

Have u got a engligh version of the ap engineering instrustions, as it says something about THE in there . see below.



What ya reckon?


Thanks
 

·
Registered
Joined
·
48 Posts
Discussion Starter #2
any ideas on the THE sensor and turning off or fixing

on my commandor the sensors that are shown are

PIM
VTA1
BOSt
WTRT
AIMT
THE = This is highlighted
O2 = this is 0v
CCO
 

·
Registered
Joined
·
48 Posts
Discussion Starter #4
Now fixed guy, i hadn't wired in Ait correctly and O2 sensor was also wired wrong. wondered why car was overfuelling :angel:
 
1 - 6 of 6 Posts
Top