MR2 Owners Club Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3,846 Posts
Discussion Starter #1
Anyone using Eagle H-beam rods in their engine? I'm about to pick up a set for my 4AGTE and was just wondering if anyone else was using them.. It says its got 19mm small end, but doesnt specify the large end.. I'd assume 42mm, but maybe 40mm? anyone know by chance?

http://www.prostreetonline.com/buy/eagle_rods/eg-4884tb3d/

Brando
 

·
Registered
Joined
·
578 Posts
oh oh oh pick me pick me! i am using eagle h beamers in my 4age but unfortunently its not running yet as of the size im not quite positive. my grandpa ordered them so i can ask him tomorrow.
 

·
Registered
Joined
·
1,812 Posts
I am using a set in my 3sgte, overkill in a na 4ag if you ask me. Just put fresh set of stockers in.
OOPS re read you are building a 4agte, so a gze crank and rods would be fine. If you go aftermarket on rods and crank you will need to balance adding to the cost. BTW the gze crank will fail before the rods will.
 

·
Registered
Joined
·
3,846 Posts
Discussion Starter #4
I might be using a HKS 5AG crank.. if not, I'll be getting some nice machine work done to my small port crank.. I'm just curious to know what size the large end is on these rods.. And either way, the bottom end will be balanced..

Brando
 
1 - 5 of 5 Posts
Top