MR2 Owners Club Forum banner

alignment specs

284 Views 2 Replies 2 Participants Last post by  kameleon/jdmmr2
hi just want everyones opinion on a agreesive street alignement settings on a gen 2 sw20
car has cusco front castor rods with later model body brackets.
jic flt-a2 coil overs
whiteline front and rear sway bars
cusco strut braces front and rear
jic rear traction rods and poly bushes
18x8 and 18x9 advan racing rs rims with 225/35+255/35 bridgestone so3 tyres.

any advice is appreciated.
1 - 3 of 3 Posts
Have you seen the auto-x FAQ? If you are not doing auto-x, don't use toe-out on the front. Keep it close to zero but slightly in. I keep the rear at zero but it's a 93. You might want more toe-in on a 91 or 92. I run -1.5 camber front and back.
cheers. ill have a read. anyone else?
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.