MR2 Owners Club Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
man i'm going crazy!! sorry. this may seem dumb but i bought trd spark plug wires for my 85 mr2. i've spent the last 3 hours trying to install them! my mistake was taking out the old ones w/out marking them first. so now i'm stuck trying to figure out which wire goes where. i went back to toyota they said the pattern is 1-3-4-2 clockwise. i tried and it still doesn't work. now i'm not sure if i'm still doing it wrong or if these plugs are not compatible. i guess to make a long story short can somebody show me a pic of their engine bay? i have an after market distributor cap that has 1 and 4 marked but it still doesn't seem to work. is there n e thing else i have to do like reset the power or something(unplug battery)? adjust idle? please help before i roll my 2 down a cliff and throw rocks at it and laugh angrily.
 

·
Registered
Joined
·
21,388 Posts
timing belt side is plug number 1, tranny side is plug number 4. your distributer cap will have numbers on it corresponding to the wires.
 
1 - 2 of 2 Posts
Top