[piapia]

I just installed the Blitz boost controller(type-s), now I havein problem to set the boost..... my engine is 2GEN JDM 3SGTE, is the fuel cut level is 12psi????
This is my frist time deal with boost controller, this boost controller is killin me,:clumsy:
I found this webside, I read it, but I still dont know how to set the boost level.... can someone please help me to set the boost level. http://www.geocities.com/MotorCity/Speedway/9589/dsbc_manual.html

 

[KBlake]

Fuel cut is between 12 and 13PSI. You will need a fuel cut defenser to raise, or eliminate fuel cut. You could also disconnect and plug the vacuum line to the stock MAP sensor in the rear, passenger side of the engine bay, but then you will have no fuel cut at all. I'd be certain to set the boost limiter up in advance. Here is another article that may be of assistance:

http://www.mkiv.com/techarticles/blitz_dsbc/index.html

HTH,

Ken

 

[piapia]

Thanks alot Ken, cause it is my frist time deal with boost controller, so i want make sure everything prefect.

 

[redblues]

How to set boost-

set gain at 5
increase ratio until you reach just below your desired boost level
increase gain until you overboost slightly
decrease ratio until your boost level is reached.

enjoy

 

[crackaonrice]

you're going to be running into fuel cut, either make the billw0t fcd or you're going to need to buy one