MR2 Owners Club Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
187 Posts
Discussion Starter · #1 ·
Hi
I was doing some reading up on engine management for an 'AGE and I came across a thread on using the 'AGE ecu for low boost setups. I was planning on running no more than 6psi. Can someone shed some more light on this topic? Because having to configure a whole MS system is a bit daunting to me... :scared:

http://mr2oc.com/showthread.php?t=70338&highlight=4age+ecu

posted by boostman
You can use the stock n/a ecu for 4psi or less (no more than 4) or you can get the GZE ecu and can make your hp goals with that.
Kyle

don't listen to this...
man what the hell are you talking about? 4psi on the stock ecu
 

·
Registered
Joined
·
7,145 Posts
^^ Currently running @ 10-12 psi with all NA electronics and GZE injectors. It's been running good so far but I need to dyno the thing soon just to verify the AF ratios and make sure those are safe. I drive it about 90 miles daily and have no issues.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top