sold
1991 3vz-fe Hardtop
6
91 NA Hardtop
Clean Title
153,600 On the Body
0 on the motor
$5500 OBO
I'm located in Northern California next to Chico, a little over an hour north of Sacramento.
Life happened, couldn't finish it. Tired of looking at it parked and reminding me of how close I came lol. Main thing left to do is exhaust. There's a few other small things left and if you're seriously interested I'll go over all that with you. Everything listed for the motor or suspension is basically new. There are 0 miles on everything, the car has just been sitting for awhile. It will start with a battery charge but you can't run it to much because of the lack of exhaust. The Y-pipe is there it just needs to be cut and welded to whatever exhaust you decide to go with. The car was setup to be able to pass CA smog inspection so charcoal canister, etc... is already installed. I have all interior/exterior parts except for stereo/audio. The paint is in great shape except for the bumpers, probably will need a repaint but I do have a Toms Rear Bumper that you may want to switch to anyway. It's currently on Non-Op so there's no DMV back fees. If you don't like the price make me an offer. I know there's a lot I'm forgetting so just ask any questions and I'll do my best to answer.
Links to build:
http://www.mr2oc.com/18-show-shine/429464-restoration-3vz-swap-build-thread.html
3VZ MR2 | My 3vz Hardtop
Engine
Rebuilt 3VZ-FE
Rebuilt Short Block (Bored out .5)
(New Pistons, Rings, Main & Rod Bearings, Thrust Washers, Freeze Plugs, Reconditioned Crankshaft)
Heads Cleaned and Rebuilt
New Toyota OEM
Full Gasket Kit
Water Pump
Ignition Wires
Timing Belt
Flywheel Bolts
Pressure Plate Bolts
Head Bolts
Tensioner
Thermostat
Throwout Bearing
Oil Filter
Fuel Filter
Distributor Cap
Distributor Rotor
Knock Sensors Wire
Bosch O2 Sensors
Beck/Arnley Oil Pump
Custom Wiring Harness (mr220v)
Stainless Steel Fuel Line
Polished Intake Plenum
Mildly Ported Intake Manifold
Walbro Fuel Pump
Transmission
E153 MR2 Turbo Trans.
Stock LSD
Stainless Clutch Line
Brass Shifter Bushings
Fidanza Flywheel
Suspension/Wheels/Brakes
KYB Front Strut Mounts
Tien Rear Pillowball Mounts (used but in great condition)
Koni Yellow Adjustable Struts
KYB Strut Boots
Eibach Sportline Springs
Tanabe Sway Bars
Prothane Suspension Bushing Kit
'93 Crossmember
'93 Rear Turbo Brakes
Drilled/Slotted Rotors Front & Rear
Exterior
Wingless Trunk
Shaved Front Side Moldings
Shaved Antenna Hole
Shaved Windshield Spray Nozzles
Custom Side Vents
Turbo Engine Cover
Metallic Silver Paint
![]()
![]()
![]()
![]()
![]()
![]()
Clean Title
153,600 On the Body
0 on the motor
$5500 OBO
I'm located in Northern California next to Chico, a little over an hour north of Sacramento.
Life happened, couldn't finish it. Tired of looking at it parked and reminding me of how close I came lol. Main thing left to do is exhaust. There's a few other small things left and if you're seriously interested I'll go over all that with you. Everything listed for the motor or suspension is basically new. There are 0 miles on everything, the car has just been sitting for awhile. It will start with a battery charge but you can't run it to much because of the lack of exhaust. The Y-pipe is there it just needs to be cut and welded to whatever exhaust you decide to go with. The car was setup to be able to pass CA smog inspection so charcoal canister, etc... is already installed. I have all interior/exterior parts except for stereo/audio. The paint is in great shape except for the bumpers, probably will need a repaint but I do have a Toms Rear Bumper that you may want to switch to anyway. It's currently on Non-Op so there's no DMV back fees. If you don't like the price make me an offer. I know there's a lot I'm forgetting so just ask any questions and I'll do my best to answer.
Links to build:
http://www.mr2oc.com/18-show-shine/429464-restoration-3vz-swap-build-thread.html
3VZ MR2 | My 3vz Hardtop
Engine
Rebuilt 3VZ-FE
Rebuilt Short Block (Bored out .5)
(New Pistons, Rings, Main & Rod Bearings, Thrust Washers, Freeze Plugs, Reconditioned Crankshaft)
Heads Cleaned and Rebuilt
New Toyota OEM
Full Gasket Kit
Water Pump
Ignition Wires
Timing Belt
Flywheel Bolts
Pressure Plate Bolts
Head Bolts
Tensioner
Thermostat
Throwout Bearing
Oil Filter
Fuel Filter
Distributor Cap
Distributor Rotor
Knock Sensors Wire
Bosch O2 Sensors
Beck/Arnley Oil Pump
Custom Wiring Harness (mr220v)
Stainless Steel Fuel Line
Polished Intake Plenum
Mildly Ported Intake Manifold
Walbro Fuel Pump
Transmission
E153 MR2 Turbo Trans.
Stock LSD
Stainless Clutch Line
Brass Shifter Bushings
Fidanza Flywheel
Suspension/Wheels/Brakes
KYB Front Strut Mounts
Tien Rear Pillowball Mounts (used but in great condition)
Koni Yellow Adjustable Struts
KYB Strut Boots
Eibach Sportline Springs
Tanabe Sway Bars
Prothane Suspension Bushing Kit
'93 Crossmember
'93 Rear Turbo Brakes
Drilled/Slotted Rotors Front & Rear
Exterior
Wingless Trunk
Shaved Front Side Moldings
Shaved Antenna Hole
Shaved Windshield Spray Nozzles
Custom Side Vents
Turbo Engine Cover
Metallic Silver Paint
