MR2 Owners Club Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. 1990-1999 MR2 Parts Swapper
    1/19/24, If you’re interested in getting a harness made, shoot me an email @ jessedlt07@gmail.com I’ll need some information before I get started so just lemme know. Hey all, hopefully this is the right spot to post this but I have been working on some ignition harnesses for 1ZZ Coil...
    $100 USD
  2. MKII, 90-99 NA & Turbo
    I am struggling figuring out what i'm missing on this harness and if anyone can point me to the right direction I would really appreciate it.
  3. 3SGTE Turbo
    Hello, ive Just rebuilt my 3sgte. However it is as its in some sort of limp mode While idle it runs beautifully revs like a charm etc. But under load it wont really pass 2100 rpm and it maxes at around 70kph(if you go downhill and let it build UP slowly.) If you down shift So you get higher...
  4. x

    MKII, 90-99 NA & Turbo
    x
  5. Common Engine Swaps and Related Discussions
    Hi everyone. Here is the issue I'm having and I'm sure someone has come across this before: I have a 1991 MR2 Turbo with a 4th generation 3sgte powertrain. I have the MR2 body harness, the MR2 ECU harness from the 2nd gen 3sgte, and the 4th gen 3sgte ECU harness. For the ECU harness, I am...
  6. 3SGTE Turbo
    I'm considering buying an mr2 for 1500$ The owner stopped in the middle of a jdm swap. It has a jdm 3sgte 3rd gen engine and ecu, but a 91 N/A body/wiring harness, what would need to be done to make it work, would a "USDM to JDM Conversion 3SGTE ECU Patch Cable (Early Gen2)" by BERK technology...
  7. 3SGTE Turbo
    I'm looking for a replacement front turn signal connector for my SW20. I've gone through the electrical diagrams and determined that the connector I need is the harness-side of "F13". As far as I can tell though, the electrical diagrams don't provide any part numbers for these connectors. Does...
  8. MKI MR2 Parts Wanted To Buy Or Trade
    I'm looking for an N1 connector. Both sides of the connector with all wires present and a few inches of wire on each side to be able to have some slack to solder. I discovered I was missing a few wires due to age while trying to further my mk1.5 project progress. P.m me here or can...
  9. Common Engine Swaps and Related Discussions
    I am doing a 92 5SFE to Gen 3 3SGTE swap. I bought a rear clip and am nearly finished with the swap. I have already taken out the wires from my body harness connector (to the ecu) and I am going to put those wires into the 22 pin connector I ordered. However, I came across a slight problem...
  10. 3SGTE Turbo
    Clearing up any confusion. Use a 1 1/2" bit and drill your hole behind the rear speaker panel as shown here: This is to completely by pass the engine bay. A half tuck, you wouldn't need to cut this hole.
1-10 of 10 Results
Top