Search Results for ‘e153’

I'm working on a turbo model swap into my 92 N/A and all I'm missing is a transmission. The engine is a gen2 3sgte from a turbo MR2. I read on Wikipedia E153s can be found in the XV20 (1997-2001) Toyota Camry V6 & the XV20 (1999-2002) Toyota Camry Solara V6. I wanted to check with the forum...

'91 MR2 non-LSD E153, missing a few important parts; slave cylinder/shift cable bracket, bell crank, shift shaft arm, shaft breather plug, shaft interlock, reverse light switch, cable sender/VSS, drain plug. Has new clutch fork, release bearing, clutch fork boot, shift shaft seal and boot, new...

Less than 2k miles on pressure plate and disc. Spec Stage 2. Kevlar material. E153 trans. $93 shipped.

Hi all, we will finally have a better highway gear option for our MR2s! PRESALE IS OPEN!!! https://www.mygarageiscoolerthanyours.com/microstore/p/e153-long-ratio-5th-gear Presale will remain open until October 21, 2022, and manufacture will begin immediately thereafter 1. WHY? We all know the...

Southbend Stage 2 Endurance clutch kit used in my E153. Come with everything in box, pressure plate, clutch disk, pilot bearing and exedy throwout bearing (throw those last two out lol) Has only about 800 miles on it, clutch disk still looks new. Nothing wrong with it, just pulled for a...

So basically, I can't shift into first from a stop/its very difficult to do so. What I've been having to do is force it into second first and then it'll go into first smoothly. When the car is moving, it shifts perfectly fine into all gears. When the car is off, it shifts perfectly fine into all...

I take the axle out leaving the stub in the trans, to avoid any spillage of transmission fluid. Why? a. the stuff is expensive, and b. there is none for sale anywhere within 2,500 miles of my location. This also avoids any risk of damaging the axle seals on removal and re-insertion of the stubs...

1992 (mfd. 1991) MR2 T-Top 3S-GTE Turbo 5-speed -734/E153 185k Miles Car is only driven in city/highway, I've never tracked it. Hey all, going to need to replace my clutch pretty soon. So far I've decided to not only replace the clutch and pressure plate with the Exedy OE Replacement but also...

Hi guys, I am new to the forum I just picked up a 1986 mr2 and am interested in doing a 3sgte swap. I have read a lot of forums about people performing these swaps and they seem like a good choice. A little background, I recently purchased the car it had been sitting for about 20 years and the...

Hi all, I am planning on putting a Quaife differential into an e153, and I'm wondering if Toyota specifies any acceptable preload range for a fully assembled transmission? The transmission is low mileage and works perfectly fine so I do not plan on replacing anything else apart from the...

Hello, on my turbo axles I snapped one out of the six bolts (left side 8mm alan key bolts). I was trying to tighten them to 100 ft-lbs. I got them to probably 80-90 ft-lbs with loctite. I didn't wanna go more with the other bolts before I snap any more. My question is, will it be safe to drive...

E153 electric speedo. SOLD. $25 USD Located in Canada but I will work with you on shipping if going across borders.

I need this for a mk1.5 project Im finishing up

I have a 3rd gen 3sgte that I recently started parting out I was going to install in my 92'N/A but I ended up getting overwhelmed since I had never performed a swap before, I ended up abandoning the project, I have since picked up another project so this stuff is up for sale,I have most of the...

Its a 91 Toyota MR2 Turbo e153 transmission with aftermarket LSD. And stubs not full axle. It has about 130k on it. It has no pop outs although 3rd gear grinds at higher speed and RPMs. This is why i took it out. Its perfect for a rebuild. I also have the 93 speed sensor. contact me for more...

Hi guys , I have a 3sgte Clutch masters fx250 BRAND NEW clutch kit for sale . Comes with alignment tool, throw out bearing, 3s pressure plate, and 3s clutch disc. Willing to sell for $400 picked up , or $400+shipping(you pay). Thanks guys !

I picked up a 94 camry v6 parts car today. I have front and rear hubs, no axles. auto tranny, and the v6 engine is for parts not as a whole, also many electrical parts. if you are interested pm me with the part you want and I will let you know if it is still available.