Search Results for ‘connector’

What connector is the one highlighted in yellow and how do i bypass it. It pairs up with the green plug that connects to the ICM. The one highlighted in yellow consists of 2 wires being 1 ground (presumably) and 1 signal wire and connects to a ground underneath the coil + module bracket Bolt...

Long story short, I picked up an MR2 with some issues with it running. I know there are many causes, and fixed a few. Runs better but not perfect. I have another post dedicated to the misplaced vacuum lines, so please answer there if you have any thoughts on it being a vacuum issue. I was...

Hi everyone, this is my first post here. I've picked up a 1992 Rev2 with a 3sge and I was doing a bit of investigation and it doesn't seem to have an o2 sensor anywhere. The downpipe needs replacing and I can't find one without an o2 port (like the one that is currently on the car). There are...

I'm reinstalling my MBC after I got my 91T 3sgte back from a turbo rebuild and a distributor replacement, and I found this connector just laying near my wastegate ports not plugged into anything. If anybody knows what it is, where it goes, and if I should leave it unplugged, I'd appreciate the...

I'm looking for a replacement front turn signal connector for my SW20. I've gone through the electrical diagrams and determined that the connector I need is the harness-side of "F13". As far as I can tell though, the electrical diagrams don't provide any part numbers for these connectors. Does...