MR2 Owners Club Forum banner

body

  1. Body panels wanted

    General MR2 Discussion
    I've been looking for front body panels for a while now but I cant seem to find any oem ones... the ones I've come across are made of fiberglass and not original design. Any suggestions or any one know if someone is selling any? Edit: forgot to mention the car, its a mr2 sw20 1991
  2. AW11 Aftermarket Front Lip

    MKI, 84-89 NA & SC
    Hey guys! My front lip on my 86' MR2 looks pretty rotten. I was wondering if any of you guys would know a front lip that fits on a 1rst gen MR2 that’s not too crazy expensive. As a teenager I'm pretty tight on budget but I'm still relatively open to the idea of saving up for one. Thanks yall!
  3. 1989 supercharged White and Red exterior parts

    1984-1989 MR2 Parts Swapper
    I'm selling a: -White Frunk lid -Red engine lid -White trunk lid (with supercharged sticker) -White 1989 trunk wing (with LED high mount) -White front bumper -White rear bumper -White doors (power windows including controller and wiring) asking $700 for all of it. I prefer pickup in...
  4. Needing replacement rear body panel for '86 MR2

    Restoration Forum
    My AW11 had nearly perfect body panels until the rear lower grill panel (below the bumper) was damaged. I need a complete replacement of this panel that starts from the very bottom and is cut at least a couple inches above where the rear bumper is mounted along with being cut with about an extra...
  5. 1991 Blue Mr2T Parts/project/engineSwap Car $1300 OBO

    1990-1999 MR2 Turbo Cars For Sale
    Up for sale is my Blue 1991 Toyota Mr2 Turbo 126333 Miles. It Has Every bolt on besides a turbo (Blown Ct27), Intake manifold, and exhaust manifold. It would be good for an engine swap. But it has a good bit of parts so ill give the entire car some time before i part it for what i can. What...
  6. Repining N/A to Turbo Connector

    Common Engine Swaps and Related Discussions
    I am doing a 92 5SFE to Gen 3 3SGTE swap. I bought a rear clip and am nearly finished with the swap. I have already taken out the wires from my body harness connector (to the ecu) and I am going to put those wires into the 22 pin connector I ordered. However, I came across a slight problem...
  7. Headlight Fitment

    MKII, 90-99 NA & Turbo
    So I was recently working to try to get my headlight to sit flush with my front bumper and do so I tried loosening the rod that pushes the headlight up and adjusting it so that the headlight would sit higher up. It sat nice and flush initially, but when I put the headlights up its like it loses...
  8. Door is beyond repair

    MK1 Interior Modification & Repair
    I recently bought an 85 aw11 and it has been hit on the passenger side door. The body of the door itself is a little rippled. I don't really mind how it looks as I got the car dirt cheap. The issue though is that the window regulator is destroyed. (crank windows). I have the window held up by...
Top