MR2 Owners Club Message Board News & Updates
National & Regional MR2 Events
Performance and Repair Garage
Shop Talk
Automotive Engineering Forums
Higher level discussions of design, theory and application of automotive systems. This is not a help forum. This forum section is designed to stimulate discussion and learning of automotive systems.
Racers Forum
Classifieds Section
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Regional MR2 Owners Club Forums
Latest Posts
-
I dyno'd my 3SGTE with the following Specs: -Front Mount Intercooler (The car is a 1999 AE111 Corolla) - 3 inch Downpipe -3 Inch Intake -3 Inch Exhaust (No cats) -CT20B Turbo (On wastegate) Stock Auto ECU -E153 Gearbox 91 Octane was used. Car only made 180whp/170ft-lbs tq. It only hits 7psi...2 replies 47 views
-
Hi all, The vehicle is a 1989 MR2 with the naturally aspirated 4A. Background: 270000 miles as of this writing and car sat for a long time before the engine-out refresh. Refresh includes: Replaced gaskets (valve cover, rear main seal, etc.) Replaced exhaust manifold with one that has no...22 replies 735 views
-
Hi all, Finally got my car with an MOT. Bled the coolant and been driving around. Coolant kept boiling up and overflowing when I stopped but it turns out the fans weren't working right. Sorted that and got a new radiator cap. After bleeding again it does seem to be building up alot of pressure...5 replies 115 views
-
The car is an '86 and it has a C-50 or C-52 manual transmission swap. The dash has the "ETC" button for the automatic transmission and the engine ECU says 4age A/T on it so I know the wiring harness is from an automatic transmission. It's hard to follow this...14 replies 4K views
-
1988 mR2 supercharged project to finish. Engine has bored 40 over, crank turned and polished, new pistons, balanced and valve job. New water pump and clutch kit. Engine and trans are assembled but not in car. All suspension parts removed, painted and urethane bushings installed. New stainless...1 reply 72 views